About vazquez.jorge

vazquez.jorge · 08-03-2007

Hello All,I have 3 3600's at home all with T1-wic dsu cards (one router has two wics). I know that I can connect all of these routers to each other using a T1 crossover, my question is: Since I am preparing for the CCNA, then CCNP, can this set-up be...

vazquez.jorge · 10-18-2009

There is a bug with one of the os on the cat6000 that does not release the telnet sessions after they should be timing out. Once you are in, there is a command to issue that shows the users currently telnetted and you should be able to clear them. I ...

vazquez.jorge · 10-18-2009

You didnt provide which protocol you are using for trunking, dot1q or isl. I will assume dot1q for now. I am suspecting that your two trunks are not configured exactly the same, cause if they were, then yes, you just created a loop which stp should t...

vazquez.jorge · 10-18-2009

1) If I do configure the 'switchport trunk allowed vlan xxx' command, does STP stop sending BPDUs for VLANs that are not allowed over that trunk? May be obvious but I cant find confirmation of that anywhere. It depends on which stp you are running, b...

vazquez.jorge · 10-18-2009

Hello, I think I can help. 1. When portfast is enable on a interface, the port instead of waiting for about 30 - 50 seconds to pass traffic, it will skip listening and learning states (each add about 15 seconds). This is a problem for access nodes on...

vazquez.jorge · 12-21-2008

I agree with Blakley.. Nat statements belong on the inside/outside interfaces, never seen them in the loopback interfaces.

Member Since	‎07-23-2007 05:48 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	21
Total Helpful Votes Received	5

User Statistics

User Activity

Router lab question. Please help..

Re: Cannot Telnet - 6506

Re: STP n TRUNK

Re: BPDUs - to send or not to send

Re: BPDUs - to send or not to send

Re: NAT on a stick problem