Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.We have some implementations of Blue Coat cache with layer2-WCCP configuration on our routers. Now we have a new requirement to configure GRE-WCCP between a Cisco3845 router and a cache-engine, which sits several hops away from the router. Wh...
Hello.I need to measure the actual throughput that goes through the FWSM module. I know it's connected with a virtual EtherChannel to the 6500, but I don't know how can I measure it.Please advise.Thanks.
Hello.I have two FWSMs, running in Failover Active/Standby mode. I would like to run OSPF on one of the FWSM's interface (int vlan2). I have two questions regarding that:1) Will both FWSMs participate in the OSPF, even when the Primary is working ?...
Can anyone tell me:1) The maximum length of the CAB-E1-DB15. So, If I order the standard cable (of 5m), and I want to make it longer, what is the maximum length ?2) The maximum length of the console rollover cable.3) What is the maximum recommended ...
Hi.The Blue Coat devices are already working in my network. They are using L2 WCCP.We got new cache engines devices (not Blue Coat), for which I need to configure GRE WCCP.Thank you very much for your replies.Boaz.
Thanks Ahsan.So there is no difference between configuring layer2-WCCP and configuring GRE-WCCP on the router ? I can use the same configuration that I've used for the layer2 WCCP installations ?So how does the router know to create a GRE tunnel bet...
Have one question about the issue: is there any throughput/capacity difference between a 1G SFP installed on the SUP720 module and 1G SFP intalled on WS-X6724-SFP, provided that both modules installed on 6509E. Thanks.
