Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a very basic question here however I am not being able to get a clue about it anywhere. We have a 2 x 4100 Firepower device cluster which has a 4x10G CCL link between the two appliances connected via 2 intermediate switches as per CISCO´s ...
Hi, I am setting up a new DNA-C hardware appliance from scratch, by reading the documentation I can see the Enterprise port is used for Internet connectivity in case Cloud port is not used thus it should be configured with the default gateway informa...
Hi, Thanks for the replies. My scenario is the one you described, however you state that when both CCL and data links goes down FPR will be removed from the cluster, in my case the FPR-B is connected to Switch-B with its CCL link only (data interface...
Hi Preston, Thanks so much for your reply. Let me ask you a few questions based on your answer as I am still not 100% clear."f you aren't using the Cloud port, you need to decide if you want the Northbound traffic to Cisco to also go through this por...
Hi Carlos,Probably what they wanted you to do was the following:ip access-list extended BLOCK_TELNET deny tcp any any eq telnet permit ip any anyDo not know what the exact statement of the question is but you can give it a try.Regards.
Hi,There is a problem with authentication for sure, National device sends out a TERMREQ once it receives credentials from remote RameyGO router. Have you verified credentials, passwords at both ends must be the same.You can also try to disable AAA f...
