Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having trouble configuring a 2951 router (IOS c2900-universalk9-mz.SPA.153-2.T) with Bell Canada DSL 15Mb up/down and a EHWIC-VA-DSL-M card. I have tried everything I can think of to get this to work without any luck. We use DSL as a failover ba...
I'm pretty new at VPN as a backup and not familiar with the 1700 series but if you are trying to get a tunnel to open don't you need a tunnel interface? I don't see one in this config.
I have uprgraded the IOS on this 2801 router to "c2801-advipservicesk9-mz.124-15.T3.bin" and I have upgraded the firmware for the HWIC-1ADSLI to "adsl_alc_20190.3-0-33.bin". I have seen no change in the initialization. I e-mailed Covad support and to...
Just a little more info. When I had debug atm events and errors on I saw this:*Apr 16 10:33:43 CDT: DSL: Downloading init_AMR-R-2.5.042_no_bist.binSo is my fw a little behind or is this the DSLAMs?
My bad, I was thinking of FW (firewall). When I do "sho dsl int atm 0/1/0" here is what I get:Router2#sho dsl int atm 0/1/0 ATM0/1/0Alcatel 20190 chipset informationLine has not yet been activated. No information available.DSL: Training log buffer...
No BRI Service. Straight ADSLoISDN. We have connectivity from PC to internet when we are using the modem. No FW on this router. Using this as VPN backup. setup as PPPoE. When tunnel comes it will go through our corp FW.
