Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco Support,
Kindly help us as one of our translated server doesn't have internet access. We can ping and access the translated server outside but no internet access from the internal side. If we remove the static nat configuration, the server ...
Hi Cisco Support,
How can we block Wireshark.exe or other Packet Sniffer applications using AVC? or what category in place?
Thank you and Best Regards!
Hi Cisco Support,
We can't view commands on the report viewer that was issue on non-cisco device. Can you assists us on how or is it supported on non-cisco devices? Is there any documentation for this kind of setup?
Hope for your fast response.
Th...
Hi Cisco Support,
Kindly help up on how we can block a specific spam incoming email from our device.
Hope for your prompt response.
Thank you
Best Regards
Hi Cisco Support,
Kindly see attached screenshot alarm for review. What could be the cause of this problem? What are the troubleshooting tips to isolate further.
Thank you and best regards!
Hi,
It would be best to purchase an X series firewall with 9.5 base version for you to use Policy Base routing. You can also add another ASA firewall for your secondary unit.
Regards,
Angelo
Site-to-Site VPN
KAO-ASA5505(config)# show crypto isakmp sa Active SA: 1 Rekey SA: 0 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 11 IKE Peer: 61.222.121.211 Type : L2L Role : initiator Rekey...
Hi again,
Is it ok for this configuration? I think you gave me is the reverse public to internal translation of the server. To make us understand is from internal to public translation.
obj net obj-host-192.168.1.250 host 192.168.1.250
nat (inside,ou...
