Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have router 1111 and Switch 1000, between them is trunk with 5 VLANs,
default gateways
sitting on the router. Just two VLANs have Internet access (VLAN 10 - via VPN to core router, and VLAN 99 local NAT) -
Switch has
default gateway
comman...
Hi Everybody,
sorry maybe stupid question. I need to reach another server via VPN (in this case FTP server, i need to download a new IOS) from router with some interfaces. I can ping and reach this server when i use source from specific interface (lo...
Hi There,I need to run only specific traffic inside VPN (for example HTTPS and ICMP). How to do it? i couldn't find solution. This one, looks like different:IPsec Data Plane Configuration Guide, Cisco IOS Release 15M&T - Crypto Access Check on Clear-...
Hi EverybodyMaybe somebody saw same issues.I have Cisco controller 3500 and some access point 2702, some of them sitting in branch offices, connected via VPN. Some offices have also Cisco and some Fortinet-s, Cisco use DMVPN and Forti standard VPN wi...
Hi There,I saw some discussions about same issue, but didn't find a final solution. I have DMVPN connection between head office and branches. Everything works fine, branches receiving routes via DMVPN and OSPF, but when i try to route all traffic to ...
Thanks Paul, i tried to switch it to normal L3
(removed ip def-gw)
and create 0.0.0.0 -> gw it also doesnt work... my understanding - 10.10.99.1 should be default GW for .99 network and after that it should reach 10.10.10.0 network...
Paul, do you ...
Thanks. Yeah i know, i created interface on switch side just for test purposes. I dont need any IPs on switch side, its L2 (just one for management)ACLs - i need to block access to internal networks, because VLAN99 will be like Guest network with int...
