About Georg Karner

Georg Karner · 07-15-2014

Hello Support-Community, I am a newbie regarding IPT-configurations.I have a UC520, which is currently set up for another SIP-Provider.Now I want to configure it for Provider Telgo (Austria) with PPPoE dial-in over the WAN Interface.How do I do this?...

Georg Karner · 06-16-2014

Dear allWe are currently facing a massive Problem with a UC320WWe changed the Voice-V-LAN from default 10.1.1.1. to 10.82.x.x and rebootet. After reboot the phones had still the 10.1.1.x-IP's but were online and registered at the UC. After calling an...

Georg Karner · 05-15-2020

Hi Marvin,i want to ask, what excatly backup from the ftd? till 6.2 i was not possible to backup the nat , vpn, routing is this possilble from 6.3?

Georg Karner · 12-27-2018

Hello, Issue still exists in 6.2.3.7 as well. BR

Georg Karner · 11-21-2017

So, I had this problem also and found this thread without answer. After another couple of minutes I found the configuration guide with the following: you do not even need to go to the expert mode to do this: > configure password cheers!

Member Since	‎12-09-2009 11:02 AM
Date Last Visited	‎12-25-2023 07:06 AM
Posts	5
Total Helpful Votes Received	11

User Statistics

User Activity

How do I configure the UC520 for SIP-Provider Telgo (Austria)?

Problem with UC320W when configuring a non-default voice v-lan ip range

Re: Backup of FirePower management Backup & Managed Device Backup

Re: CSCvi63474 - Unable to edit the system policy of a SFR module via ASDM after upgrading to 6.2.2 - 1

Re: change admin password for Cisco FTD