Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was trying to configure PoS ( Packet over SDH ) on STM-1 Interface of IMA3G-IMSG module of ASr-903 router .
Could some one help in providing detail .
I am using IOS XE 17.15 version
Dear Team ,
I have customer end router with E3 interface which supports non-channelized E3 interface .
When I am connecting to E3 port of IMA3G-IMSG card of ASR 903 router , neither controller comes up nor interface protocol comes up with G.751 fra...
Hi All ,
We have configured IP rtp compression on E1 link but the packets are not getting compressed. If anyone has any clue , kindly advise.
Although IP header compression is ON although RTP packets are coming on interface still we are not receivin...
Refer below configuration :
show run controller e3 0/2/15
Building configuration...
Current configuration : 121 bytes
!
controller E3 0/2/15
no snmp trap link-status
no channelized
framing g751
cablelength short
channel-group 0
end
