I have a problem with a VPN between a Meraki MZ and a Cisco ASA when using IKEv2
The tunnel connects, but there is only one child sa so the tunnel wont entertain passing traffic for the other subnets that should be going over the tunnel.
I found this...
I am trying to set up an IPSec VPN between two sites. I have created IPSec VPN Tunnels between sites before, however I am getting a bit confused with the issue I face. Site 1 (Remote, I have no control over) uses the subnet 192.168.253.0 /24 in thei...
Looking for some advice regarding Policing traffic.
We have 6509 switches at one site that connect to 3750 switches at another site via a 100Mb/s link.
police bps burst-normal burst-max conform-action action exceed-action action violate-action ac...
We have a MPLS connection between sites and we also have a National Ethernet connection between the remote sites and HQ.
My Query is If I configure IP SLA on our switches like this:
ip sla 1 icmp-echo 192.168.121.153 timeout 1000 threshold 2 frequen...
I have set up a Cisco 877W router to connect to our business broadband, however it doesn't give out DNS information to the clients.
A client will get an IP Address from DHCP ok, but doesn't get any DNS information. I would expect that it would get ...
extended burst (be) must be between 1000 and 32000000 for this interfaceConfiguration failed!
So I changed it to this
police 95000000 17812500 32000000 conform-action transmit exceed-action drop violate-action drop
The reason I had it the way I...
I have attached a image which gives you an idea of how this is connected.
I have left off the other three satellite sites as this would just confuse matters.
There are two OSPF instances.
One which is tagged and the MPLS router propagates that and another one that will propagate over the National Ethernet link.
