Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Can someone help me on the case below?We have a Cisco CATALYST 6506, CatOS based, with the following config:Switch 6506 (enable) sh verWS-C6506-E Software, Version NmpSW: 8.4(5)System Bootstrap Version: 12.2System Boot Image File is 'bootdisk:c...
Hello,Can anyone help me with the case below:I'm trying to replace a SUP module on Cisco CATALYST 6509. (Cat OS)After I insert the new module I got the error:SYS-5-SUP_REDMISMATCH:Standby supervisor 2 redundancy/power mgmt board detection mismatchand...
Hello, Good morning Can anyone help me with the case below? We have a Cisco aironet 1162N connected to a Wireless Controller (LIGHTWEIGHT mode), the device failed and it needs to be replaced. We have a Cisco aironet 1142N in stock availab...
Hello,Can someone help me with a power supply problem...?Switch cisco WS-C3750-24P is showing "Unavail" from sh env allSwitch3750#sh env allFAN is OKTEMPERATURE is OKSW PID Serial# Status Sys Pwr PoE Pwr Watts-- ---...
Hi everyone,I have an alert from monitoring system about: “ fan for this system is not in the NORMAL state”.In the switch I found that the problem is with fex 3, see below:Nexus5020# sh env fex 3 fanFan Fex: 3:----------------------------------------...
I'll try with router#clear line vty 1-10Also, I tried:Switch 6506 (enable) disconnect 2Telnet session from l325.com is executing a command.Retry laterWhere "2" was session IDI didn't see the option: "disconnect "
Hello, AP: 1262 is dead. I'm not able to see old configuration. new AP is not connected to the network yet.My queston is: there are any process to configure the new AP (settings like: AP host name, vlan, etc)? via console session before connect it t...
