Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have the following questionsMy company uses a cisco system including core to switch, the user system when accessing the internet will use DNS managed by ADMost of the departments use the internet but there are a few rooms that do not use the inte...
My system uses a server as a PDC, at the user side I set the DNS for the computer as the IP of the PDC, sometimes I find that my firewall device does not detect which website is being accessed by any computer. internally, I only found out that my ser...
In the morning my system was warned that the drive was about to be full, after looking for the cause I found that there was a rather large file that took up 64Gb, I tried for the system not to take any log in and out. of the system user but it doesn'...
Currently I have 1 Asa 5525-x hardware using Cisco Fire Linux OS v6.2.2 (build 11).Cisco ASA5525-X Threat Defense v6.2.2.5 (build 57)- Before that I used the FMC version of Cisco Firepower Management Center for VMWareSerial Number NoneSoftware Versio...
My company is rebuilding the DMZ model, my subnet will be primarily due to the core level DHCP switch and the firewall asa I use primarily to give the internet subnet, nat and the route for the VPN network to see each other, but there is one thing A...
- Do you think a signature collection is needed to protest this issue, I bet 9/10 people will agree- I'm a network engineer also got hit with the firewall 5525 with firepower, I've seen the new version do some cool things that fortigate did a long ti...
Thank you.The problem is that I cannot remove svi on VLAN99, I created the route-map and the correct traceroute to the inside-2 (dmz) port as intended, but only failed where the internal network could not be communicated. with zone dmz.
Normally I will do the same but the system has only one blade server, I build the VMware system on it and it is connected to the core switch by a physical path (6-way trunk), including the FMC's I'm also in it and all layer 2 switches (end users) foc...
