Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Try to determine if it is possible to have a setup where we have multiple CE routers connecting to the same PE router exchange routes if they are running different routing protocols but in the same VRFTo simplify the implemention to some thing...
Hi,I have been attempting to configure QoS on the nexus 4k blade switch to set the CoS value of incoming traffic off the internal 10G interfaces, but have come across an error on which I can find no information on. Any advice would be appreciatedConf...
I have an interesting problem in which enabling EIGRP on the PE for connecting to the CE router, causes OSPF in the MPLS routers to drop their neighbour and establish the session again. I have attached a diagram showing the MPLS environment with the ...
Hi all,I have seen a few questions posted on the forum about EoMPLS issues, but the one I have is different to those already posted and responded too.I have attached a document which includes the topology, configurations and output from commands to s...
Hi Calin,We still need to redistribute EIGRP and OSPF into MPBGP to be advertised over the MPLS network. Once I add the redistribution statements between EIGRP and MPBGP and between OSPF and MPBGP I can now longer add mutual redistribution statements...
Giuseppe Hi,We have a request into the TAC at the present but the response I received back was that the OSPF fast hello implementation doesn't provide enough room for error. After hours of testing, the only configuration that proved successfully was ...
Hi Giuseppe,Removing the configuration for the etherchannel between the CE and PE made no difference to the outcome, OSPF still drops out because of the dead timer expiring.You're understanding is correct on my choice of fast hello's as BFD doesn't s...
Hello Giuseppe,What seems to fix the problem is removing from OSPF the fast hello packets feature. It would appear that applying EIGRP causes an interrupt to the routing process which they results in the OSPF dead timer expiring.Not sure why this is ...
Harold,Many thanks with your reply. Changing it from a VLAN-based EoMPLS configuration to a Port-Based EoMPLS configuration brought the VC up.I was hoping on using VLAN based so I could try to do VLAN re-writing on the 6509. But not being classed as ...
