I have a Cisco network with several Cisco switches(the core switch being a 4506). We have a Siemens Highpath 4000 handling our VOIP and for some reason the 4000 is showing bad IP quality to and from the NCUI2 card. I have hard set the ports to 100/...
I have a Hipath 4000 Communication Server that has two STMI2 cards connected to my Cisco 4506 on the same vlan. One STMI2 card is active and the other is in standby. The active card holds the data and ip address for the VOIP system. If at any time ...
I am trying to reload an image on my AP 1231G-A-K9, and it is not allowing me to go to the ap: prompt when pressing ESC and the flash load#############. Thanks in advance
I have configured two new vlans. I am able to ping those vlans via any switch on the network. The problem is when I try to ping it from a machine that has been setup on that vlan with a static ip, the request times out.
I HAVE FOUND THE PROBLEM!!!I had done some vlan prunning in the past on the trunk between 2 sites, and forgot about it. Once I added the vlan the the switchport allow it is working fine.I greatly appreceiate all of your help.Thanks
HERE IS THE PORT INFO(where the machine with the static address resides) :interface GigabitEthernet4/19 switchport access vlan 120 switchport mode accessHERE IS HOW THE VLAN IS CONFIGURED:interface Vlan120 description ip address 10.30.120.1 255.255....
Sorry Rick I didn't make myself clear. I can ping the new vlan's ip from another pc that is on a different vlan. I can not ping the machine that is set with a static ip nor can I ping anything from the machine with the static address. there is no ACL...
Thanks for responding. I have verified that the ip, netmask, and gateway are set correctly and still unable to ping the gateway. The strange thing is I can ping it from another terminal that is on a different vlan. Could it be that I have the port co...
