Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a problem regarding throughput over wireless when the peers of the data transfer are in different VLAN (separate networks).Topology:I have a 3560 L3 switch configured with two VLANs, VLAN1 is the PC Wired network and VLAN2 is the PC Wireles...
Hi,is it possible to use the outdoor AIR-ANT2547V-N dual-band antenna with AIR-CAP1602e access-points, using a N-Type to RP-TNC converter?We have a couple of 1602e AP and we need to go for outdoor coverage, and we were thinking about installing the A...
Hello,we've been installing this new equipment on a new Call Manager solution for a costumer. Everithing worked fine but now we're facing the following problem:- We have a few units connected to an HP Switch;- The switch is VLAN capable;- The switch ...
Hello,I'm configuring a network with a centralized WLSE and several remote sites all with different subnetworks.I've configured a WDS and a WDS Backup for each of the networks.All was going well until I noticed that when I added the last site, APs fr...
Hello,I've been having some problems with the linux version of WCS. Sometimes, and I still don't know why the Database server stops. To activate it again I need to restart the service using the WCSStart script. Is anyone having similar problems? The ...
I've read that this equipment doesn't have autonomous software and that leaves us with Mobility Express or WLC.
I also think that by now there is no Mesh support in ME? So only WLC left.
And by WLC I mean the real physical one, as I was told that vWL...
We’ve found the origin of the problem. It had to do with a badly configured gateway IP address in the DHCP Pool, for the network in VLAN1. We were experiencing asymmetric routing with one leg of the communication been routed through a Cisco 800 serie...
Hi! Thank you for you answers,Here is the output of the commands:Switch#sh mls qos QoS is disabledQoS ip packet dscp rewrite is enabledSwitch#sh run int g0/13Building configuration...Current configuration : 150 bytes!interface GigabitEthernet0/13 swi...
