Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a scenario where I have anyconnect vpns terminating to a Cisco FTD (configured with FMC). There are multiple connection profiles, that have separate ip pools, which then enter a catalyst 9500 L3 switch (main router) with multiple vrfs. I wou...
I have a lot of Teradici thin clients connected to a Cisco 9300 access layer switch with Port Security enabled on the ports. Port security will trip at random intervals (sometimes 5 hours, sometimes, 12) and shutdown the port. When logs are checked...
I am having issues creating an Trunked Etherchannel between a switch and an ASA firepower 4120. I have an etherchannel up that is an access etherchannel and it works fine, the problem comes when I try to trunk it. I have tried a non-etherchannel tr...
Thank you Paul, The key to finding my solution was the "global" command at the end of the ip route vrf statement. Using your example, I had ip route 2.2.20 255.255.255.0 gig0/1ip route vrf VRF 1.1.1.0 255.255.255.0 1.1.1.2and ip route 1.1.1.0 255.2...
Thank you, This makes sense. I tried adding the ip vrf receive to the interface, but it does not appear to be an available command on this vlan interface for some reason.SW-1(config-if)#ip vrf ? autoclassify Enable IP VRF Autoclassify feature ...
This is only happening on ports where Thin Clients are connected and it has happened with different thin clients in different physical locations and on different vlanned networks. I have yet to be able to capture this on a SPAN port as it is very unp...
The best way I have found to do this is by enabling the shell processing feature.you can turn this on globally by using"shell processing enable" in global configuration mode to turn it on just for the session you can use"terminal shell" from global e...
