Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I boot up my ISR4331/KP router I get the below Invalid input error messages
cisco ISR4331/K9 (1RU) processor with 1648789K/6147K bytes of memory.Processor board ID FLM2147W0SR3 Gigabit Ethernet interfaces32768K bytes of non-volatile configurat...
I’m receiving errors on a new Cisco ISR4331/K9 router that I haven't done any configurations on. I was hoping someone could shed some light on why the
following messages are coming up on startup.
Error1:-------no valid BOOT image foundFinal autoboot ...
I ended up being able to put a support case in with cisco and the solutions were:
1) Add line "boot system flash bootflash:isr4300-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin" to config to get rid of error no valid BOOT image found
2) I would h...
I felt the same way but even though the router is brand new and I've stated to Cisco I only want information on the error they refuse to talk to anyone unless the router has a smartnet contract.
Thank You so much for your quick response. The router IOS was not upgraded actually. I took it out of the box and the errors that displayed were the ones from the factory install. After adding the config line to the router "boot system flash isr4300-...