Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCan anybody help me I'm trying to configure a standalone 7940 SIP :-I have put in all the credentials supplied by entanet when I dial out I get a "We are unable to connect this call please contact customer services" message from enta.The phone is c...
HiI have 2 IP phones 7940's connected to a C1760 router configured with 2xFXS ports and 2x FXO ports running CME v4.1The 2 phones can each complete a successful outgoing call over the pstn line. When an INCOMING call is being received the caller hear...
Can anybody help me.I am trying to configure a CME setup on a 1760 router using a POTS system - connecting through a FXO port to a standard single BT feature analogue line.I can make outgoing calls OKAll incoming caller heres is a single ring.thanksS...
I am having a problem with a 1760 router configured with a 2 port FXO (pots) port, I have created a outgoing dial plan which works fine but I am struggling with getting / finding a correct config for a incoming call I have 2 extensions 1001 & 1002 co...
HiI was being a bit dim and not reading the CCNA Voice guidePage 271 of the Cisco Press guide:-When an incoming signal is detected CME doesn't know what to do with it unless you specify a PLAR (Private Line Automatic Ringdown)config:-voice-port 1/0cp...
