Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I setup a Aironet 1250 for testing many months ago. While I remember the IP address and the Logon details, I don't have the Management URL.When browsing to the IP address, I only receive the following;The server XX.XX.XX.XX at level_1 or v...
Hello,I've just installed a Aironet 1250 and AIR-ANT2430V-R antenna.I could do with some pointers on configuring the 2.4Ghz radio interface.Role: Access PointGoal: Blanket office coverageChannel width: 20Mhz or 40+ ?External Antenna Configuration: En...
Could anyone tell me if the WS-C6509 is manageable via the Cisco Network Assistant.By default, I cannot add this to any Community, though it is viewable as a device in CNA. I thought maybe an IOS upgrade? (boot system flash disk0:s222-advipservicesk9...
I have just installed another unit and it's working fine.The problem with my orginal still exists, even after updating the IOS to match the most recent purchase.It would appear it's not loading the Menu on the left of the page.Yes I can enter Enable ...
As you can see from the attached PNG image - I'm only being shown a basic overview screen when logging on as an Enable User.I remember I was able to configure the entire device from the web interface.Let me know what you think
The connectors are fasted tighlty - though I will revisit.I measured the speed and signal quality using a 2530p Elitebook/PROSet during various area surveys.
