Hello All, I have an SG350X-48P (firmware 2.3.5.63) being used as an access switch that I just plugged two POE cameras into. I am showing no power use (0%) from either the GUI or from the CLI using "show power inline" which obviously can't be true si...
Hi All,
I read about this problem online and it said to try https instead of http but this does not work. Login hangs at 70% for any account entered and from any workstation, O/S or browser.
Ideas?
Yes the cameras go off if they are unplugged from the switch and power on on when plugged into it. There are no injectors on these units. We have dozens of cameras both IP and coax so I am very familiar with how it all works.Most of our other IP cams...
If you mean connect directly to the switch with that special cable no I have not tried that. Assuming I can (and I assume I can since the switch is still working and logs me 70% of the way in) how will that help me get to the Web UI?