FA1/5-1/6 should be GI1/1-1/2Any reason why the unit is indicating all ports as FAX/X when in fact it should be indicating two GI ports?. Is there a way to solve this hardware configuration? FA1/5 and FA1/6 should be Gi1/1 and GI1/2.. Thank You.
Hi Guys, I need assistance finding why I'm not able to access the WLC GUI. I am not able to ping the management interface IP address neither. Everything was working fine until I added EACL to my switch. So I revert the configuration to previous one b...
I am not able to get the AP's to join the WLC, Here is the WLC sysinfo and AP SH version info, and the boot up process for both APs as well. Thank you.
Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Syst...
NewSwitch#sh interface GI1/1^% Invalid input detected at '^' marker. Here is the result when I enter "sh interfaces"FastEthernet1/5 is down, line protocol is down (notconnect)Hardware is Fast Ethernet, address is f07f.06e1.8d85 (bia f07f.06e1.8d85)MT...
Not able to ping gateway IP, I can pin its own WLC IP address. I would think it is an issue with the Switch but all interfaces are indicating connected when I run the sh inter status command.