Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,We have a situation where the modules of our FI are offline, however the fixed modules are working as expected:Mod Ports Module-Type Model Status
--- ----- --------------------------------- -----------...
Hey forums, so I have a situationI used to be able to SSH connect from my Catalyst to my Nexus, doing like a nested SSH situationAfter I updated the Nexus to the version 8.4.2, when I attempt to access the Nexus, it closes my Catalyst SSH sessionI am...
Hello,So we are having a connectivity issue inside our virtual VMware environmentFirst a few things about our environment:Fabric Interconnects configured as EHMWe have multiple VLANs configured on our Fabric InterconnectsThe ESXi blades have at least...
Greetings forums, I have a questionSo we have a Cisco UCS C240M5 with a VIC 1387 on the mLOM slot, configured as stand alonethe only way to use this card for I/O is with some FI + UCSM or with a Nexus with AdapterFEX support (like a Nexus 5500)?this ...
Greetings,
So we have 3 UCS that have a FC HBA card installed, but when you check the PCI Adapters tab in the CIMC, this slot appears as "Not Loaded" in the Option ROM Status
Weirdly enough, when you check the BIOS Parameter configuration you see t...
nothing on the nexus, and its like a ssh close session instead of crashnot sure why when i logging into the nexus, it closes the session on the catalyst
Hey Wes, we are using originating port ID,I was thinking about deleting even one of the vNICs to discard the factor of load balancing, but it is configured properly
Hi Kirk, thanks for your replyWhat do you mean with sanity check?I did check and mapped the right vNICs as the uplink of the vSwitches, and tagged the right VLANs on the vNICsAnd I have no issue with the MAC of the ESXi vmNICs as they are the same of...
