Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to setup two Nexus 9300 series switches for a vPC but keep running into an issue. When I run "ping 10.1.1.2 vrf heartbeat it works on both switches with the IP of the other switch. When I do a show vpc brief it says I'm down.vPC domain id ...
Hello, I have two ASR routers running BGP between two connections. I am new to this so please bear with me. Basically we are running BGP at our hub office and would like to pad routes to certain branch offices to connection A or B. Is it possible to ...
Hello,
I am using a layer 3 switch as the Edge router for my ISP connection.
I've created 2 vlans, one for the WAN with the transport block a /30 and then another vlan for the LAN side which is a /26
Here is what I've created.
interface Vlan10descrip...
I have a 4500x TOR switch that has fans and power supplies that push air from front to back. I've purchased 2 new power supplies and 5 fans that push the air back to front. When I put in the new power supplies and fans the switch never turns on the ...
Hello, this is probably not a good question and not possible but thought I'd still ask. I've got a /26 network and I have a decent amount of IP's that I don't use. I am wanting to setup a test environment with a /29 subnet. If I was to take a group o...
Currently here is what I have on both ASRsrouter bgp 12345bgp log-neighbor-changesneighbor 4.4.1.1 remote-as 3356neighbor 4.5.19.1 remote-as 3356neighbor 150.150.150.254 remote-as 12345!address-family ipv4network 150.150.150.0 mask 255.255.255.0redis...
Correct, so to have branch a prefer isp 1 do I do this? router bgp XYZneighbor 50.50.50.1 route-map California-out out!route-map California-out permit 10match ip address 60.60.60.0 255.255.255.248 California-outset local-preference 200 My question al...
I have a hub and spoke VPN topology, but BGP is only running at the hub for redundancy on our internet. We have the same ISP for both internet circuits and run bgp between the two circuits. The branch offices have no routing protocol between them and...
Let me see if I have this correct. I would need to add this command to both my Cisco ASR 920 routers router bgp XYZneighbor 50.50.50.1 route-map California-out out!route-map California-out permit 10match ip address prefix-list California-outset local...
