I have new APs 2802i, they are connected to a 2504 WLC. The controller is running 8.2.166.0 code. The AP's register fine but i have two issues. First the CAPWAP preferred mode (which i have set to IP V4 globall) shows up as not-configured. Secondly...
Hi,I have a 2921 router with CME and need help to set up a password when prompted want to make calls and enter the password if they can not make calls outside
I am trying to configure dial-peer to block calls to different extensions, the router already have configured the followingand configured to define that extencion nations can make calls or only extenciones
dial-peer cor custom name internal name AGC...
From the beginning, the AP 2802i had firmware 8.3.102.0.
From what I see when updating the firmware, I would have to do it with a version greater than or equal to 8.3.102.0, since the firmware that the WLC has is 8.2.166.0.
Do you think that this i...
Hi Flavio,
but to install another serious version in the WLC, right?
what I do not want is to affect other APs that I have running in the WLC.
Can a firmware be installed only for the 2802i APs?
Hi vivek
I was a problem with the configuration of the dial-peerbecause I set the dial-peer as follows, but without changing the dial-peer 10 which is what gives them permission to make callsYou think does not work because I need to modify settings d...
to set the ephone-dn 1 have to enter the password to make calls this would be the right way?
voice lpcor enablevoice lpcor custom!group 10 Managergroup 11 LocalUser!!voice lpcor policy Manageraccept LocalUsar facaccept Manager facservice fac!!applic...
