Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone managed to access Starlink Stats from the LAN side of their MX? I can see packets leave the MX but never return when I use the capture capability on the MX for this. I suspect the Firewall is dropping had a ticket open with Meraki but th...
I have the situation where I need to talk to multiple different Radius servers depending on the WLAN. Some of the WLANs are not able to route traffic over my entire network, and within these secure areas the Radius server for that area sit. Is ther...
I have a 877W router that we use for home users that have multiple SSIDs (one for home use, one for work). The SSID is broadcast, but the Acer Aspire One Netbook doesn't reliably see this VLAN, but other devices in the house does. ACER says it is n...
I am setting up a 877w for home users. Essentially I have 2 Bridge groups, 2 Vlans and 2Wlans. All is working fine until I start on the PEAP configuration. On the switch port if I plug in my laptop it is properly authenicated against on our ISA/Radiu...
I have a Cisco 5510 that has a DMZ setup on it and supports Remote Access via the legacy client, not web or SSL. While on VPN I can get to all internal resources, have no problems. However I cannot conect to any resouce in the Dmz. I've look at the N...
Hey I like that idea. I've ordered a micro usb RJ45 ethernet adapter. When I get that I'll have a look and see what I can do. Only wish this was more a API than a l web page...
That lack of outbound NAT I think is the challenge. I'm going to stick with this setup and start a nano-pi-w and see if I can plug in a Mirco Usb LAN interface (gotta find one first) and use that to act as a VNC accessbile bridge like device. I can...
Thanks... This solution still have challenges. If I have a device on that VLAN then I can read the stats page. If I am on another VLAN I cannot. It looks like that DISHY must have some ARP issues as it can never return the packet to a off VLAN devic...
Hi Scott,Thanks for the reply. We have the setup we have as two companies in the middle of a JV and different support models/needs in a new office. I don't want to have two WLCs and APs throughout the building so we are doing 1 with different needs...
