Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,
I purchased some used SPA50x off of eBay and am unable to get them to do anything other than display Downloading
When plugged in they do the usual Initialize Network and then display Downloading of the following files
SEP_mac_address_.cnf.x...
Hi there,Just purchased an RV220W for a customer to replace a WRVS4400N that had no support for One-to-One NAT and have found the One-to-one NAT for this router is only marginally better.I have three WAN addresses and three devices to map them to. Wi...
I purchased some used SPA50X off of eBay and am unable to get them out of SPCP mode.
Upon bootup they display Downloading and change between the following files
SEPmac.cnf.xmlXMLDefault508G.cnf.xmlXMLDefault.cnf.xml
I have setup a TFTP server and the...
Thanks tekliu,That was what I was looking for.I didn't realize that Access Rules on the RV220W actually enabled you to specify NAT as part of the settings.The working settings were as follows:Action: Always AllowService: SSH-TCPSend to Local Server (...
This question is 100% about routing and 0% about wireless. Looking at the posts in the Small Business - Wireless forum I believe this to be in the right place.Cheers,Kevin
What should be entered in the Voice Mail Server parameter? Should it be the server's IP address or the IP address followed by the port number?Also what is Voice Mail Subscribe Interval for? The default is 86400 which is one day in seconds?My Message ...
