Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a guest SSID configured in my WLC. I also have 2 ISE appliances (Primary/Secondary) that I use to do the web auth on my guest SSID.In the config of my SSID (Security / Layer 3 / Web Policy), I selected "Web Auth Type: External" and I had to en...
I have a router that I configured to emulate the MPLS network of a customer. Each customer sites are connected to this router and have a EIGRP adjacency with it. On the MPLS router, a VRF has been configured for each sites and route leaking is used f...
Hello,In a lab, I have a router with 2 EIGRP adjacencies. Both neighbors are advertising a route for the 10.254.254.1/32 subnet. One of them has an internal route and the other is an external route (redistributed from OSPF).With both adjacencies up, ...
Hello,Is it possible to use wildcard (*) or regexp in ACS 5.2? For example, I would like to create an End Station Filter that would match when the DNIS is *somethingThanks
Since we moved a couple of cards on 2 6500 in VSS we keep gettingOperationallyDown faults on the slots where the cards were. Example: Event_DescriptionOperationallyDownDevice IPx.x.x.xDevice TypeSwitches and HubsFault Last Updated At25-Mar-2011 10:51...
Out of curiosity, on what OS are you running LMS?I did two install for two different customer recently, one on Win2k3 R2 and one on Win2k8 R2. The install on Win2k3 R2 have no problem, the install on Win2k8 R2 have the incorrect fault count problem, ...
Hi,I had the same problem on Win2k8 R2. After running the device discovery LMS 4 found 57 devices but they were invisible in the DCR.As a test, I tryed to manually add a device but it would not appear. I tryed adding it manually again but this time I...
