Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,The UCCX compatability guide for UCCX 7.0(2)SU2 has three Nuance applications listed as supported however it does not list Nuance Vocalizer version 5.0 as being supported, on Vocalizer v4.0. I have installed both Nuance Recognizer v...
I know this configuration is not supported but someone told me that they had setup a 7914 expansion module to work on a 7940 phone. Has anyone else tried this and gotten it to work?
Hello Anand,I actually have setup/configured the UCCX v8.5(1) system to point at our Nuance Recognizer v8.5 and Vocalizer v4.0 server and it is registered and working properly over port 554 however when I try to setup the connection to our new Nuance...
Hello Everyone,I am trying to get Nuance Recognizer v9.0 and Vocalizer v5.0 running on a server and believe that it is setup correctly via the Nuance documentation guide however when I attempt to point our Cisco Contact Center Express v8.5(1)SU2 at t...
Our problem has been resolved, these devices associate to the correct vlan and pickup a voice IP address. I am running 3.3(10) and have used the following switchport config. We have also found that by setting the switchport access to the voice vlan...
I am also running 4.1(3)sr2 and used to experience the same type of problems until they released a firmware version that resolved this problem. We found that the problem to be with cdp and that the switch didn't recognize this as a voice device and ...
We are experiencing the same type of problems and are running CM4.1(3).We have found that if you set the switchport and the phone to 100mb, full-duplex the device will not continually reboot unless there is a loss of power. We believe that there is ...
