Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are attempting to emulate a setup we currently have on our PBX. Scenario is a user picks up a phone, and the "phone" (or PBX) automatically dials a given extension. What we have now is IOS routers configured by the CCM with MGCP. I tried ...
Hello,We recently implemented a new WAN that is essentially bonded T1s served up to us as a copper hand off. All our remote switches (3560s) connect to our core (3750s). The core is running at layer 3, each remote location has a separate VLAN (and ...
We are in the process of implementing a new wireless VOIP solution and have just got done rolling out our new wireless infrastructure. We have problems in quite a few areas where the calls cut out, the phone loses service, or other add scenarios. I...
Hello,I just wanted to verify I'm actually understanding some concepts here. A while back I posted about QoS for our Voice VLAN and it was suggested that I need to consider the Wired QoS Protocol support inside of the QoS Profile for the Platinum pr...
Hello,I apologize if this has been covered before but I can't seem to find an absolute answer (probably because there isn't one) on how we should configure the switch ports for our 5508 WLC. We have a 5508 WLC with 4 ports plugged into our 3750X Sta...
So is the reason that stcapp is seemingly "unable" to start because on the CUCM the gateway isn't configured that way, thus it can't register? In addition, if I change the device on CUCM those two FXS ports must be SCCP not MGCP I presume. Thanks m...
Thank you very much for your response. In QoS we have WMM as required, we do not have either of the 7920 options checked. The phone is running 1.4.1SR1 it appears. So then if I am interpretting what you are saying, as long as the APs are below 105...
Stephen Rodriguez wrote:For the QoS mls QoS trust cos is correct. You don't need to do the auto QoS commands.Thanks for your reply Steve,Quick question I asked above. Does it hurt to execute the auto qos commands on a port or is it completely uneces...
Justin Kurynny wrote:carldu,If there’s any chance of congestion on the port, then leaving the other commands is probably a good idea. Otherwise, you typically see documentation focuse on the trust dscp statement. In summary: dscp for APs, CoS for con...
