Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi i have two supervisor engines on my cisco 4510r router, one of the supervisor engines is stuck in rommon mode, i tried to boot the image on the bootflash but it's corrupted, i followed the following document to boot the image on my tftp server, bu...
i want to allow a server on my Internal to communicate with a server on my dmz over a specific port (i.e 5555) and vice versa, from outside i can connect to the dmz server over https. here is my config, i have only replaced the ips with dumy ip's. i ...
Hi all,Bit of a problem that I hope someone can help with. I would like to allow traffic from our internal network through the external network. I can’t access internet from internal network but I can access form external network. I have the followin...
Hi i have two locations let's call them location A and B i'm using a microwave radio link between the two locations and behind each location i have a switch which is connected to radio. now my question is is't useful to create two vlans one for trunk...
Hi can any one assist on this, last comment about erassing bootflash dosn't work. The image is on bootflash,in rommon there is no command for format. is there any way to update the stuck engine with a different ios and then bring it to synch after wi...
i have compared the checksum of the image on my tftp with cisco cco and they match, and the copying of the image from the tftp to DRAM is ok as evident from previus output but i think when it reloads it loads the old image which is still on the bootf...
guys thanks for your inputs, i don't think there is anything wrong with the nats but i have a routing problem, i can't ping or connect to any vlan on my distribution switch from asa i can only ping the internal interface but no other ip inside my net...
HI Adding the above worked but it had a counter effect now we can not access internet we are using the below nat for internet. we have also limited the above static nats to a host instead of a network we only want to communicate with one server from ...
