Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi team, i have problem with an port in nexus 3K connected to an equipement work in 10 mb and full duplex i put under the port the config:int eth 1/7sw mo accsw acc vlan Xduplex fullspeed 10 but the port always work in half duplex and is not stablepl...
hi all i have problem in my fmc cisco virtual i configured the fmc to take the time from NTP server in my AD server and i allowed the port 123/UDP to this server but the FMC always use the own time 127.127.1.1 remote refid st t when poll reach delay...
hi all i have problem in my fmc cisco virtual i configured the fmc to take the time from NTP server in my AD server and i allowed the port 123/UDP to this server but the FMC always use the own time 127.127.1.1 remote refid st t when poll reach delay...
hi team, i have two ftd 2110on HA with two etherchannel ports to cisco core switch in the switch i have an error message mac flapping, when i track the mac address !! is the mac of the ftd flapping between the two etherchannel.i configured the ha ac...
hello all,
please guy , i migrate all my configuration from an ASA to new firewall cisco FTD
after the migration i have an issue of the timeout connection UDP
this is the command of timeout in ASA
timeout conn 4:00:00 half-closed 0:10:00 udp ...
yes i put the port auto autoi had this result in the show logg command2020 Apr 6 13:28:18 C7SWiOOB01 %ETHPORT-5-SPEED: Interface Ethernet1/7, operati2020 Apr 6 13:28:18 C7SWiOOB01 %ETHPORT-5-IF_DUPLEX: Interface Ethernet1/7, operational duplex mode c...
hello,thank you for your replyit's not stable because sametimes i can see the mac of equipement sametimes2) Yes the equipement was connected in another switch 3850 and it's in full duplex and fonctional stable
hi friend any help with this issue, please !!!? the two firewalls FTD 2110 after some time with HA config go to Active/active mode the problem is dual active triggeredI upgraded the two firewalls to the recommended version but always the same proble...
