Actually it's not that odd.  "show run" was built for the configuration purposes.  It allows you to see the changes to the configuration as you are making them.  In contrast, "show start" allows you to see the static/saved configuration which is much...

Do your PCI auditors need to see the running config?  Or would the start-up config be sufficient?  If so you can just do:username test privilege 3 password 0 testprivilege exec level 3 show startup-config Then "show startup" should give them what t...

I had the same issue. When I put in the inspect pptp command, I got the same results as you did. FWIW - I entered the old "fixup protocol pptp 1723" (which is just supposed to add the "inspect pptp", right?). Now all of a sudden it's working. Onl...