Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I would like to know about any existing procedure to know when a user attempted to login using TACACS+ in the ACS server reports. In brief, I want to know if there is any feature or option in CiscoSecure ACS to know when a user attempted to lo...
Hello,I would like to know about any existing procedure to know when a user attempted to login using TACACS+ in the ACS server reports.In brief, I want to know if there is any feature or option in CiscoSecure ACS to know when a user attempted to logi...
Hi, I do get the following error while saving the configuration to memory on my ASA box. HCL-BMB-ASA-PRI# wr mem Building configuration... Cryptochecksum: 42bceaba 27adb265 edcb9fbd 60a1761e %Error opening disk0:/.private/startup-config (File or dire...
I do have a site where we have got internet connection via ethernet port. We did make an ipsec over GRE tunnel from that site to our HO in US. Router model Cisco 2821 at the remote site and 3845 at HO.We have got another internet link onto the serial...
Hi,I've a department which has been physically residing in a common area. We do have a 2960 switch in that common area connected to the users of my department. I want to implement port-security so that no other user can connect to this switch port ly...
You can also refer http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a0080094959.shtml#cfg_wsPlease vote the post if it helps
Hi Arif,You are indeed right, it does support Layer3 features. i didn't notice the 4232 card which you mentioned.So you need to enter the RSM module (4232 card) from the switch by typing session (slot number where this card is installed). Passing the...
So if I interpret correctly, you have a 24-port switch where in first port is connected to a DHCP server and the rest are hosts.The hosts are unable to receive IP addresses from the DHCP server, please confirm if we are right till here
Hi,I hope by now you might have well known of the solution. But I would just like to add that here of the possible solution which I think of for your situation.1. Delete the vlan database file on the 29xx switches.2. Configure VTP in transparent3. Cr...
