Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am planning to do ethernet portchannel with two Gi ethernet ports. Any experience how L3 port channel works. If i put a ip address under e.g interface Port-channel1 config does it inherit/copy to interface GigabitEthernet 1/1 and 1/2 config.inter...
We get this error message if we try to do hsrp stanby group number over 999. Switch is 3750 stack. E.g syntax "standby 2844 ip x.x.x.xdoes not work and error "%FHRP group not consistent with already configured groups on the switch stack" appears. If ...
I want to create new vlan id but i get message "% Failed to create VLANs xxxxSpanning-tree extend system-id need to be enabled." If i enable that is there going to be any changes or break in spannintree topology.thanksJuha
HiIs it possible to move LMS product to HP blade server farm. Any experience about that. Are there going to be any harm if do so. We are planning to "copy" LMS server to HP blade server.thanksJuha
I d like to make syslog automated action when %RTD-1-ADDR_FLAP appears to syslog. I create and try to select it from list of syslogs. Any idea how to find from that list anything when defining new message type.There is quite hard to find anything fro...
Hi and thanks for answer.Switch is WS-C3750G-24TS-E. we tryed config like below. Tryed to take standby ver 2 to production.interface Vlan2842ip vrf forwarding testip address 10.1.1.1 255.255.255.240standby version 2standby 2842 ip x.x.x.xstandby 2842...
