Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have a very Variety problem to start with. Here We have a campus Network With total Switching and no routing scenario.We have Cisco 4006 as a Core Switch and Cisco 2950 as access layer Switch . Here we dont have any VLANS or Trunking and all ...
Hi all , I had a little strange problerm with my router, iam using 2801 series router with IOS of 12.4(2) Advanced Enterprise IP version.The Fast Ethernet port is showing output packets and output bytes even when the interface is not connected to any...
Hi all I have got two ISP Connections and With PIX 515 i just want to load balance my outgoing traffic to internet.Does PIX Support load balancing Can we have Two default routes to two Routers in PIX 515?
Hi all I am sorry that i make u feel bore of same question.I went through all the posts regarding this and am not able to troubleshoot the issue .I am able to Connect to my ASA and establish a tunnel I am able to ping my ASA insideI am able to run T...
Hi all I am having A C4500 distribution layer switch connected to 5 access layer switches i want to block a user connecting to the lan on the basis of MAC ADDRESS i wrote an VLAN ACCESS LIST to match the mac address of the user using mac access list ...
Hi All I am again Unsuccesful with the test , can any one send me the example configurations that should be done on Cisco ACS 5.1 and also in the Cisco RSA Authentication Manager as well . So that i can follow the steps easily.The Question i have i...
Hi Sachin & GaneshThanks for your Help,I did the observation of CPU and Memory Utilization after connecting the Trunk Link it was quite normal , but i noted a point before i connected the Uplink the CPU Utilization is 4% but after i connect it it,s a...
The Spanning Tree for the port on SWA towards SWB is forwading Stateand Similarly the Spanning Tree output for SWB towards SWA is also in forwarding State.
Hi arul I went through ur post and did following changesip pool - 10.1.1.1 - 10.1.1.25 255.255.255.0 and i have a default route in my Core Switch to ASA 5520 ip route 0.0.0.0 0.0.0.0 172.20.0.10we use EIGRP as our Internal Routing Protocol and I crea...
