Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone ever tried running the Attendant Console software from a Citrix Thin-client workstation? Is this supported by Cisco?I haven't found any documentation saying yes or no, and I don't have a Citrix server to test it on. Anyone run across thi...
Does anyone know of a way to load Unity Bridge and start the services without having a TR114 board installed? We need to simulate an Octel integration but only as far as running the Unity Bridge software. We don't actually need to have any hardware...
Running on CallManager 4.0.2a SR1...I have created a translation pattern to try to block any calls to international area codes (i.e. to Guam, Dominican Republic, etc). I set the pattern to match on to 9.1[2-9]XX[2-9]XXXXXX and set the translation pa...
I have CallManager 4.0(2a) and have configured a single Attendant Console user. The hunt group has line 1 for that user as the first member and then the extension for the Auto Attendant as the second (and last) "always route" member. The phone the ...
I have setup a remote office using a PIX 501 connected via VPN to a 3005 concentrator at the central location. Routing between the sites works fine, I can ping the phones from the CallManager, but the phones don't register and their status screens s...
Just as an aside, Cisco did finally add the VG224 to BAT under CallManager 6. See the below for details:http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/bat/6_0_1/t08gwins.html#wp1345635Better late than never...
Couple options, though I am not sure which will work for your situation:1) Remove the English (US) from the Loaded Languages lists in Unity SA:Under "Configuration-->Phone Languages" and "Configuration-->GUI" Languages screens, move the English (US) ...
Also, you want to keep in mind that MobilityManager requires an H.323 gateway (not MGCP or SCCP) that supports VXML.This means that if you currently have MGCP gateways, you would have to reconfigure one for H.323 or add a new gateway to support MM. ...
It looks like the jitter is specific to the call legs from the 2 2651 routers that are hosting E1 circuits. I would start your search for the problem at those routers. Take a look at the Quality of Service setup on those routers and make sure that ...
