Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Can someone please help me how to apply an authentication mentioned on mentioned modal of cisco ap.
I tried many time but could not do so.I want my SSID to broadcast which have done but is open authentication and everyone is able to connect the...
Hi,
I need a problem to understand MLS & MQC properly. Can someone please help to understand these in depth?
Will be thankful for your help..
Regards!!
Hi,
Here,
1. I am using CP-PWR-CUBE-3 with Model: PSA18U-480(JMC).
but..!!!
Thanks a lot dear. My AP is placed in the critical wireless zone from where i could only be able to access via remote secession, i found here of socket problem whats wh...
HI,
Hope you are doing good.
Here,
1. My device is power up with an adopter and connected via Ethernet to my Cisco switch.
2. No, i didn't lookup any unknown logs on CLI.
Regards,
Joni..
Dear Ric,
My AP (AIR-CAP1602E-E-K9) is rebooting by itself after some time. Can you please help me to understand that what the problem is?
Will you please help me? I need your brotherly assistant on this issue.
Hope you may not be annoyed.
Rega...
Hi,
Thanks *Ric Beeching* to Reply
No, I think it is not in Autonomous. PFA the below attached configuration files with (show running-config & show version)
*Could it be the problem of it that it is not putting out authentication commands?
Rega...