Authentication Problem with Cisco AIR-CAP1602E-E-K9

[A123450Ha]

Hi,

Can someone please help me how to apply an authentication mentioned on mentioned modal of cisco ap.

I tried many time but could not do so.I want my SSID to broadcast which have done but is open authentication and everyone is able to connect the ap.

Thanks & Regards,

Joni..

[Ric Beeching]

Hi,

Is this an autonmous SSID? Can you paste your config?

Ric

[A123450Ha]

Hi,

Thanks *Ric Beeching* to Reply 

No, I think it is not in Autonomous. PFA the below attached configuration files with (show running-config & show version)

*Could it be the problem of it that it is not putting out authentication commands? 

Regards,

Joni..

[Ric Beeching · Accepted solution]

Hi Joni,

That is Autonomous! No problem, try this to configure your SSID with a pre-shared key and encrypt with AES.

conf t
int d1
encryption vlan 102 mode ciphers aes-ccm
exit

dot11 ssid evo
authentication key-management wpa v 2
wpa-psk ascii 0 <CHOOSE KEY>
end

Ric

[A123450Ha]

Hi Ric,
Thanks for your support. it have been done now(My issue cleared).

Regards,
Joni..

[A123450Ha]

Dear Ric,

My AP (AIR-CAP1602E-E-K9) is rebooting by itself after some time. Can you please help me to understand that what the problem is?

Will you please help me? I need your brotherly assistant on this issue.

Hope you may not be annoyed.

Regards,

Joni..

[Ric Beeching]

I can try... are you running it off a power injector or a PoE switch? Do you see any logs on the switch if so?

Cheers,
Ric

[A123450Ha]

HI,

Hope you are doing good.

Here,

1. My device is power up with an adopter and connected via Ethernet to my Cisco switch.

2. No, i didn't lookup any unknown logs on CLI.

Regards,

Joni..

[Ric Beeching]

What power adapter are you using to provide power to the AP?
Can you paste the output of a 'show version' from your AP?
On your switch can you also do a 'show power inline'

Thanks,
Ric

[A123450Ha]

Hi,

Here,

1. I am using CP-PWR-CUBE-3 with Model: PSA18U-480(JMC).

but..!!!

Thanks a lot dear. My AP is placed in the critical wireless zone from where i could only be able to access via remote secession, i found here of socket problem whats why it is restarting by itself with random time space.

Thanks for you corporation..

<I would be happy to have you a friendly contact if you feel easy via fb or other? It will be a pleasure to me>

Regards,

Joni..

[Ric Beeching]

Haha no problem I was going to suggest checking cables/plugs as it is often a physical issue. Glad you resolved it!

I'll have to pass on your generous offer, I'm only here to help others on the forum!

Thanks,
Ric