I currently have my default config 7.0.3  on the UC500. I cant connect to the CCA with my static IP which is setup to where they match the default IPs networks. I use 10.1.1.1 and 192.168.10.1 to connect. Im not sure if it has to do with the access l...

Hi all,I recently delete my startup configuration, so now I have no configuration on my UC500. When I try to access the GUI and CCA using 10.1.1.1, It doesn't connect on either. The way im doing this is with my PC connected to a LAN port on the UC 50...

Im still new at this, but how can I ping between my laptop and UC500. I have a cable connected in one of the PoE ports on the UC to my PC ethernet port. I did the ping command from the UC to my PC and vice versa but never got it. I would always get a...

I am having an issue using tftp to copy the IOS image into my UC 500. I get an "Error Opening" message then I get a (socket error) at the end.The Ip address, File source and destination are all right. Im not sure what else I could be doing wrong.

I can't seem to figure out how to fix this probelm. Each time I try to boot the system I always end up in the boot command prompt "switch:". I've tried boot flash, removing directories/files but I keep getting a "permission denied" message. I've also...