Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we have a set of FWSM running 3.2(1)Rules are set to allow ICMP both inbound and outbound.However traceroute gives some unexpected results, half of the hosts do not respond. It also produces the following message in the log.%FWSM-4-313004:Denied I...
Hi,We have an FWSM running 3.1.3 in routed mode, single context. It has been running fine (as far as we can tell) since July06.It runs in a 6509 with Sup32/CatOS 8.5.3The MSFC is not being used and has not been configured.The FWSM routes traffic betw...
Hi,a quick question: how do you set the time on the FWSM. Can you set it to use NTP server liek the routers do? Or does the module receive the clock from the 6500 switch?I am interested in this for both 2.2 and 3.1 FWSM releases.Thank you,Remy
Hi,here is a prblem I am not sure how to solve. For some reason, I need to setup a router with NAT. Addresses from our LAN (10.1.1.0 /24) would be NATed to a private IP assigned to us by a service provider (192.168.1.6) Where things get interesting i...
I need to setup Lan-to-Lan VPNs to between 3 routers. Each router has one interface on our public LAN and one int on a private 192.168 network. I have sucessfully configured the first pair of routers, with an IPsec connection between R1 and R2. Tryi...
Our FWSM is currenlty running version 3.2(1)The bug ID TAC gave me is: CSCsj53485From what I was told, this affects version 3.1(5) and 3.1(6) and will be addressed in 3.1(7)It seems it also affects 3.2(1) and will be addressed in 3.2(2)I do not have ...
Hi,I set icmp and icmp error inspection, ALCs allow icmp from source to destination.Still, traceroute traffic get somewhat disrupted. It is also inconsistent. Several attempts few minutes appart do not lead to the same result.I talked to TAC about th...
Thanks for the input. I thought about this, routing is the first thing I checked.All systems involved are directly connected. No dynamic routing involved.I opened a case with TAC, they are still looking into it.
Hi Marquez,I had similar a issue with our backup software. TCP connection would remian open for too long and the FWSM would eventually terminate then.I change the timeout value to 8 hours and the problem was fixed.The command on our FWSM running v2.3...
