Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I know it is a very very old devices we see a very very weird thing in the switch , we try to connect a device to one the of the interface On the endpoint device side, I can see the interface is up, no issues, but the switch side shows downwe admin-d...
How to prevent fabric advertising the host routes to the outside network I was thinking the redistribute direct route-map XXX can do the work, but in fact, the host routes still learn from leaf-node and are received by BorderLeaf, and then BL adverti...
HI team , working on Private vlan configuration in EVPN-Vxlan Fabric I have leaf1 port24 ---host1, leaf2 port 24---host2 primary vlan id 400 ,, community vlan id 402Leaf1-port24 and leaf2-port24 are put in vlan402 as belowswitchportswitchport mode p...
I have a requirement which needs your help, many thanks in advance for example, vlan 200 , 10.10.10.0/24I have hsrp in 2-N7Ks in this vlan , but with a different group with different VIPunder SVI 200 hsrp 1 --VIP1 --10.10.10.1 and hsrp 2--VIP2--10.10...
Hi team , need your help with the " clear ip nat translation outside <local ip> <global ip >I tried few times , but always get the " %translations not found",, but actually the translations are still there the reason I dont want to do the clear ip na...
First, thanks, LGThe interface is defaulted, there is no configuration, and I just "no shut" itinterface still show down, not in erridisable mode as well GigabitEthernet0/1 is down, line protocol is down (notconnect) Hardware is Gigabit Ethernet, an...
ya, that's the problem, those servers are old and I'm may not able to identify each one of them ...I am just trying to see if there is an alternate way to avoid this part. I was wondering if there is PBR can be applied based on the hsrp group
