About cbfs

cbfs · 05-16-2018

For some reason neither Administration -> Locate Device nor "system light" in the CLI work on the SG350XG-24F. I also have a SG350XG-2F10 and SG250X-48P and it works fine on both of them. I'm running firmware version 2.3.5.63. Does anyone know if t...

cbfs · 05-15-2018

I have an SG350 switch that's been reset to factory defaults, but I cannot log in to the switch using the console port. Once I type the username and press enter, it jumps past the password and tells me that authentication has failed. It never gives m...

cbfs · 05-17-2018

@tommls wrote: Trying to configure newly purchased sg350 switches. 1) how do I configure all the ports to be in trunk mode via the CLI?? -- 28 ports one at a time is not the ideal solution If you're comfortable using the CLI, you can configure rang...

cbfs · 05-17-2018

For anyone who hits the same issue, my terminal app was sending CR+LF when I pressed the enter key. The switch was registering both the CR and the LF as pressing enter, which would cause it to always skip over the password field.

cbfs · 05-16-2018

@Rosica Sareva wrote: Hello, What is the password you are entering? Was this working before you reset the switches? I’m trying to use “cisco”, but it never even gives me the chance to enter a password, it just skips right over the password fie...

Member Since	‎05-15-2018 11:01 PM
Date Last Visited	‎02-10-2021 02:09 AM
Posts	5

User Statistics

User Activity

SG350XG-24F locate device/system light not working

Cannot login using console port on SG350

Re: SG350 configuration problems

Re: Cannot login using console port on SG350

Re: Cannot login using console port on SG350