Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a device template which I am using to configure my device's password. Here the is the results:
admin@ncs(config)# devices device nexus apply-template template-name test variable { name pass value 'cisco' } apply-template-result {device n...
Thank you so much! I made the mistake of assuming it had something to do with how XPath is configured, but of course it was as simple as utilizing a backslash within the text value.Much appreciated.
You can try to power down the switch, power it back on with the mode button pressed. You will eventually arrive at the switch: prompt. From there you can either delete or rename the existing config. If nothing works even for attempting to factory res...
Telnet/ssh works from shell, correct?
I agree that you should enable device trace to raw format and attempt to connect. You can enable verbose logging of the devel by editing the ncs.conf to <trace> instead of info.
