Hello Friends,
There are need to configure port connectivity between Cisco FI 6248 FC port & Broade SAN switch. So can I create port channel between them. So will get redundancy as well as more bandwidth.
As this configuration will going to do first ...
There are need to install Cisco UCS C3160 Rack Server.This server comes with two types of hdd1. SSD 2 Nos. 128 GB each.2. SAS 42 Nos 4 TB each.
As I checked BOM but only mention asUCSCC3X60SVRN2 00010 - UCS C3X60 Server Node E5-2620 v2 CPU 256GB4GB R...
Hi,
One of our customer have 2 5108 Chassis with 4 blade servers. Each chassis have 2 blade servers. Customer required redundancy in such a way that blade servers should work fine in case swapped from one chassis to other. No manual work required aft...
Hi,
I have 4 servers in 2 Chassis(5108) & 2 Fabric Interconnects- 6248UP want to disassociate service profile from one of server which created using Service profile template.
Please guide procedure for the same.
Regards,
Ravi
Thanks for reply.
As customer going to put 4 cables from each FI to SAN brocade switch. So how will link aggregation or redundancy will happened in case one or more physical link goes down ?
Already configured each FI ports (17,18,19,20) are configur...
I created clone of earlier service profile then created service profile template & assigned to Servers.
It works fine.... Thanks.
Now supposed want to swap blade from one chassis to other chassis so what will have to do? What is procedure to work wit...
Dear Kirk,
Initially blade servers were installed with same template. Now 2 servers networking settings need to change for specific vLANs. As I am able to modify changes but it is replicating on all 4 servers may be due to templates. The current requ...
Thanks for reply,
Want to add few more details. As each blade have 2 SD-cards (Raid-1) & installed ESXi with configuration of 10 vNIC & 2 vHBA. I want to keep all this setting as it is.
So will there any impact if I disassociate Service Profile?
Will...
