Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Preface with new to VoIP and am trying to create a small lab environment for students to get a little bit of exposure to VoIP and QoS as part of a networking course.Using a 2901 with CUCME 10.5. Have 4 phones registered and working fine - 2 7962's a...
We purchased a Cisco WLC 2504 and Cisco Aironet AP1815I for use in the classroom as part of our Cisco Academy. We are a community college and do IT and CCNA training for students. Students were working to get the AP's connected to the WLC and through...
Some of the phones did come from our CIS department which uses CUCM. I was told phones were factory reset before being donated to our department. I will cross my fingers and hope that maybe a few phones were NOT factory reset and this whole thing m...
Thanks maren - will work through that. This case has the same issue and same output for file names. https://community.cisco.com/t5/ip-telephony-and-phones/7962-sccp-phone-registration-to-cme/td-p/4012051 One solution was to delete the ITL file - thi...
I appreciate the tenacity!!! I too being a lifelong IT guy can't seem to rest or just move on until resolved. This one is particularly challenging as I have not worked with VoIP at all. Been a Cisco guy for a long time but focus on routing and swi...
Hey Maren - it's making progress and I greatly appreciate it. We've all looked over config errors many times. I incorporated the adjusted load lines - worked perfect.R1_2911(config-telephony)#load 7942 SCCP42.8-5-4SUpdating CNF filesCNF files updat...
I hope this helps - I have 2 7962's - one works, one does not. I identified early on they were on different firmware (hope I'm using the proper term). The 7962 that does not work - TNP62.8-3-1-21a.bin. 7962 that does work - TNP62.9-3-1-57.binThis...
