Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have PGW 9.3(2) with two AS5350 configured both for termination of IMTs and used as SLT (two E1 links with channel 16 used for SS7 signaling). The PGW is not in nailed mode, but in call-routing mode.The test I made is very simple - making a call...
Hi All,I have a CallManager v3.1(3a). The following services die without any events logged:PAServerPASPCS_en_USPASPREC_en_USStarting them by hand didn't helps.Somebody else with such kind of problem?Regards,Angel
I see too more things:1. patterns '.T' and 'T' are not exactly the same when related to DID as I remember. Try '.T' and make sure that at the destination of 'session target' the call is routed corectly with the so mached destination number.2. As I re...
Hi,I will sugest you the following configuration changes:1. In 'map-class frame-relay 128k ':no frame-relay adaptive-shaping frame-relay cir 128000frame-relay mincir 128000frame-relay bc 1280frame-relay be 0frame-relay fair-queueframe-relay fragment ...
Hi,Can you try the following 3 configurations:1. On the PRI/BRI interface configuration put:isdn overlap-receivingThis will enable overlap receiving on the interface in case your Telecom sends you overlap digits. By default the cisco interface receiv...
