Hi,We have been expended our subnet from 192.168.0.0/24 to 192.168.0.0/21. We can ping some stations others do not respond to ping. Ip configuration is the same on all printers we have been testing. Z:\>ping 192.168.1.100 Pinging 192.168.1.100 w...
HiI am in the proccess to change my subnet mask from 192.168.0.0/24 to 192.168.0.0/21 bit due to shortage of ip addressesI am stuck at cisco 2811 router I as don't know exctly which access-list I need to apply.below is my current access-listaccess-li...
Hi Experts,I am running into some issue. I have site to site vpn which is running great. Now I am trying to configure remote access to my clients through vpn client.The problem right now is that only one crypto map is supported per interface.I under...
Hi i have some problems to allow ssh on 5510 through outside interfacei have enabled the ssh to get through but looks like some configuration has to be done to allow local usersi'm getting error message Permission denied, please try again.Thanks
Hi there,Cisco used to have css11500.I can't find anything about current load balancers , especially for web serversDo they still have it or it's being slightly changed?Thanks
so in this case the best way is to split network into 8 subnets each with 24 bit, correct?the way how our switches setup is a start so one main switch 48 ports 1GB which servers all the servers and all other switches connected to it too.Should I crea...
HI Giuslar,thank you very much for your detailed reply.Can you please give me some more details about this line/21 subnet is near to be too big (too many broadcasts)i have about 5 cisco switches all ports are being used.All servers have static ip's w...
Thank you for the note.I have notices that i can't access LAN through VPN after changing to subnet as described in post above.I understand that it's related to access-list once again and based on your explanation tried to change it but no luck so fa...
Hi,thanks for the link still no luck with my dynamic vpn accessI still can't ping my Lan from VPN nor browse the internet here is my config.please let me know what i am doing wrongThanks againhostname myrouter!boot-start-markerboot system flash c280...