Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi.we have some catalyst 3750 stacks with l2 and l3 software installed.the stack is just propperly running if all the members have the same minor-software-releas.im not sure how to do a major-software-release upgrade of a stack. a minor-software-rele...
Hy.I Had some problems with Port Security on Cat4000 running 6.3.(4)a There was a recommendation to change to CatOS 8.3.(2)GLX.Now i have still problems to configure port security. The dynamicaly secured MAC Address did not remain on the port after d...
I have questions about WGB350. Is the WGB350 supported for PEAP?- If yes, does it work with Active Directory?Are there plans, for the WGB350 to develop further?- new SW versions, IOS?Regards.Marcel
hi.I have installed 350 series bridges to connect two buildings. the distance is 50m. the software running on the bridges is 12.02T1.the problem is that the noneroot bridge initiates "lost authentication with parent" approximately every 30 minutes. a...
in the stack i have just one ip address. do i have to load the image via tftp into all flashs(1-n) of the stack?is it enough to change the bootstatement on the stackmaster?
Im not shure if my respons was ok. so i do it again.there is a problem to protect a port (after dynamic learning the MAC-Adress) against an unwanted client on a Switchport. Im not sure if it is "Sticky secure" on IOS based switches. In earlier CatOS ...
