Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloSeeking help for routing issue,Primary route for R3 to reach R1 is via SPBackup route for R3 to reach R1 is via R2When backup link is up then packet drop is noticed from R3 to R1R2----------------R3---------(service_provider)-------------R1R2---...
HiR1 takes backup link to reach R2 rather than MPLS route. On R1 there is mutual redistribution of OSPF with BGP.Diagram on the setup is attached. Any cluecheersRR
Hi,My requirement is to map an Active Directory group with ACS group and allow only this group to ssh/telnet to Firewall and Router.So far I am only able to map group on ACS. wht steps are required on ACS and Firewall or Router, in case ACS is down ...
Hi,My Setup is site-2-site VPN with mix of GRE with IPSEC Tunnel and IPSEC Tunnel.Routing protocol is OSPFAll Sites are connecting to HQHQ to Site AHQ to Site B HQ to Site CHQ to Site D Some of the Tunnels are not stable, I suspect overlapping of net...
Thank you Giuseppe for the reply.Yes you are correct the diagram labels were incorrect, sorry about this.I modified the config to make it simple to be more focus on issue, but seems it become unclearCE is the backbone router ( For us the backbone an...
jon,its misunderstanding, all traffic for R2 initiating from R1 should take MPLS as primary route and Backup link as secondary route.R1 and R2 config is attachedcheersRR
Jon,From R1 I need to reach 10.10.10.0/23 network on R2R1#sh ip route 10.10.10.0Routing entry for 10.10.10.0/23 Known via "ospf 10", distance 110, metric 2, type intra area Redistributing via bgp 7190 Advertised by bgp 7190 Last update from 192.1...
