Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 1800 ISR router running IOS 12.4(22)T5.Clientless SSL VN is configured and working, and has three bookmarks.When logged into Clientless SSL VPN and displaying the portal page in IE-8, the bookmarks are visible and functioning as expect...
I have noticed in AP1100 series documentation that loopback interfaces are to be avoided.This begs the question of what to use in their place for a source interface for snmp, logging, etc. ?Thanks.
Hello,For reference I have attached the following:Network DiagramPing Results TableConfigurations for 1811 router, ap1121g root access point, ap1121g wgb.I am seeking assistance with the following problem.Referring to the attached network diagram, I ...
I have an autonomous wireless AP model c1121G, and an ISR model c851w.Is there a CLI command that will show the radio's transmitter power level of these devices?regards
I am confused as to the methods available to implement Dial Backup on an 1811 ISR. My router's WAN is connected to a cable modem via FA0.In reading the 1811 software configuration guide (chapter 13, page 13-5), I have viewed a table listing "Dial Bac...
Justin,That is what I am using now. But, in the spirit of best practices I was using a loopback for snmp, logging, etc., for the obvious reasons.Then I noticed the important notes concerning loopbacks, on ap1100 series image release notes, during th...
Justin,Got the config back to the way it was before we went 'bare bones', minus what I mention previously. With the config stable, I have upgraded the image. It still worked on 12.3(8)JA2. As you recall Feature Navigator indicated that this was the ...
Justin,So far I have reconstructed the configuration's major functions without breaking the WGBing. There are some remnants of the orginal config that will not be put back as they are either not needed or where incorrect to begin with.I'm still on t...
Justin,Thanks for forcing me to do the bare-bones test.It works!!I have connectivity from a pc behind the hp-switch (see network diagram) to the internet.I can also reach devices behind the hp-switch from the root-ap, which I could not before.Now I ...
