Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're upgrading our switches from Catalyst to Meraki. I got a Catalyst 2960 and on a few switchports it has the "flowcontrol receive desired" command. These are ports that connects to either servers, VMs or iDRAC systems.These switches were put in ...
MX64 - client has a specific request that for a few computers at their location, they want the users to only have access to a small list of websites that is related to their work. I'm thinking using AD Security Group and Group Policies would do the ...
Quick question about MTU...Having some point-to-point issue with voice over IP phones and the vendor is asking me to try changing the MTU. My question is;Can I have a different MTU setting from the core switch to the remote location (via point-to-po...
I have a strange issue that I'm having a difficult time locating the source and solution.I work for a county government. We have multiple locations but all communications go back to the Core Switch in the Admin building. The Core switch is currentl...
I have a small cisco lab consisting of an 8-port 3560 switch, a 2851 router and a cisco POE WAP, which I have set up for my CCNA studies. A few weeks ago I was able to get it onto the internet with no problem, however I took it back off to reconfigu...
That has not helped. I'm not sure if I'm doing something wrong.I've added the computer that I'm testing in, was still able to access websites that should be blocked. I went as far as trying to had my username (AD account) into the security group, n...
Ah ok, and I'm thinking to "append" with the block list and then "override" with the allowed list. That sounds logical to me as long as it goes in that order, checking the block list first then the allowed list.I'll be giving this a try in the next ...
I am aware of using *... that's not my question here. I'm trying to make sure that the group policy will be set to block all websites and then refer to the "allow list" to override the default "block/deny all" rule.
I think they're desperate to try and pin this issue on us and a network issue when I'm pretty confident that it is not a network issue, but an issue with their equipment on our network.But I'm playing along with them for a little bit before I put my ...
Been a while, just wanted to update everyone on this in case anyone comes across something similar.What I ended up doing was turning off RSTP on the Meraki Switches due to some possible "incompatibility" with Cisco Catalyst STP processes. This is ju...
